Press the rotary knob or press
seconds, input mode ends automatically. Pressing
value is not applied and the display returns to the current ACTUAL value.
Temperature-related indicators:
i s activated whenever the heater is running.
During the warm-up phase, every 10s an estimated remaining warm-up time scrolls across
the display for 3s instead of the current temperature.
i s activated when the CURRENT temperature corresponds with the TARGET
temperature, allowing for a certain deviation of X°.
A rrow up is activated when the temperature is rising (if below TARGET
temperature, arrow is blinking), arrow down is activated when the temperature is dropping,
e.g. during a transfer or if the heat plate is still hotter than the set target temperature.
i s generally activated in the event of faults or errors, and when there is a significant
deviation between TARGET and CURRENT temperature (value outside of a range that
allows for pressing).
Setting the time:
p ush briefly, symbol in the display flashes. Turning the rotary knob clockwise
increases time, counter-clockwise decreases. Press the rotary knob or press
store value. If no input occurs for 5 seconds, input mode ends automatically. Pressing
w ill exit the input mode, the display will return to its original value.
Secabo GmbH Hochstatt 6-8 85283 Wolnzach Germany mail@secabo.com www.secabo.com
to store the s et value. If no input occurs for 5
10
e xits input mode, the set
t o
Need help?
Do you have a question about the TC5 SMART and is the answer not in the manual?
Questions and answers