Table of Contents
Advertisement
TROUBLESHOOTING
If you hear 3 short beeps when you press TALK, you are out of range.
• Does the base need to be relocated?
• Charge battery.
• Make sure base is not plugged into an outlet with another household
appliance.
Phone beeps
• Place handset in base for a minimum of 20 seconds to reset the security
code. If that does not work, charge battery for 12 continuous hours.
• Clean charging contacts on handset and base with a soft cloth or an
eraser.
• See solutions for No dial tone.
• Replace battery.
Dialing from Memory
• Did you program the directory keys correctly?
• Did you follow proper dialing sequence?
• Make sure the TONE/PULSE dialing mode is set to TONE or PULSE
according to your phone service.
• Did you reprogram directory after a power outage or battery replacement?
Charge / In Use LED on base keeps flasing
• Provided your phone company offers voice mail indicator service and you
subscribe to it, the CHARGE/IN USE LED flashes when the phone is in use
to indicate there is a message waiting. It stops flashing after the message
has been reviewed.
No dial tone/phone will not dial out
• Check that the AC power adapter is plugged into a working AC power outlet.
• Check all telephone cord connections or try another wall jack
• Do a basic reset of the phone: Disconnect the phone from the telephone line
and remove the battery for 30 minutes and then re-install as instructed by the
manual.
• Try other phones in the house to ensure it is not a line problem with the
telephone company.
• Was the battery charged for at least 12 - 15 hours?
• Is the "LOW BATTERY INDICATOR" on?
sy5822 10 april.p65
26
26
2006/5/12, ¤U¤È 02:52
Advertisement
Table of Contents
