Installation From A Usb Memory Stick - Viavi MTS 2000 User Manual

Chapter 16 Maintenance and Troubleshooting
Maintenance procedure
2 On the Home page, press Settings key to open the System
Settings page.
3 In I/O Interfaces, on the line Ethernet, select Mode: Dynamic.
4 In the Upgrade Server box:
– On the line Address Type, select Server Name or IP Address.
– Enter the Server Name (if Server Name has been previously
selected) or the Server Address (if IP Address has been previously
selected)
5 In the I/O Interfaces box:
– On the line Use proxy, select No, Manual or Auto wether a proxy
is used or not.
6 Press, in succession,
Upgrade > Upgrade via
The message Verify IP address of PC server appears.
7 Click on Continue.
The list of the software versions available on the PC is displayed next
to the versions installed on the 2000 Platform (see
page

Installation from a USB memory stick

You must be equipped with a USB memory stick with a minimum capacity
of 128 Mo.
Before installing the upgrade, you must format the USB memory stick (see
"Formatting the USB memory stick onto the 2000 Platform" on page
1 Once formatted, disconnect the USB memory stick from the 2000
Platform using the key Eject USB in the Media Utilities page.
176
175).
As for any media formatting, please note that all data pres-
ent on the USB memory stick will be irremediably lost.
User Manual
Expert Tools > Upgrades > Software
Ethernet.
79000000203 Rev. 005
Figure 92 on
188).