Chapter 6 Scope
Configuring the P5000i Scope
Figure 18
The line below Filenaming shows the name of the file according to the
parameters entered.
In the Logo parameter, click on right arrow key and select in the Explorer
a JPG file which will represent the Logo displayed on the upper left part of
the report
Fiber
The Fiber box allows to configure the fiber plugged to the scope.
On the line Fiber Id, use the edition keypad, which will display by clicking
on the right arrow key, to enter a specific name for the fiber.
On the line Fiber Number, use the numeric keypad, which will display by
clicking on the right arrow key, to enter the fiber number.
On the line Change fiber Nbr, select if the fiber number must be modified
after each results saving:
No: the fiber number is not modified at each saving
Increment; the fiber number is automatically incremented at each
results saving
Decrement: the fiber number is automatically decremented at each
results saving.
52
Edition keypad for filenaming
User Manual
Pre-defined
parameters for
filenaming
79000000203 Rev. 005