Changing The Voltage And Spi Mode - Microchip Technology MPLAB User Manual

®
MPLAB Starter Kit for Serial Memory Products User's Guide
2.4 CHANGE THE VOLTAGE AND SPI MODE
The Memory Starter Kit also gives you the ability to change voltage or change SPI
modes by clicking on the Settings button. If you are using SPI you can select Mode 1,1
or Mode 0,0. If your device has the ability to work at multiple voltages you can select
from two on-board voltages, either 3.3V or 5.0V. In addition, the Memory Starter Kit can
be used with external voltages by changing the jumper to External V
provided power and ground connections. It is up to the user to make sure that his/her
device can support voltages lower than 3.3V.
DS22087B-page 10
and using the
DD
© 2008 Microchip Technology Inc.