Wheel Balancing Screen Page Description - Ravaglioli G3.140R Instruction Manual

1297-M007-1_R
GB
Page 29 of 60
NORMALLY DURING THE DETEC-
TION OF MEASUREMENTS, THE
1ST ACTIVE FIELD WILL BE THE
ONE FOR THE SELECTION OF THE
PROGRAM.
THERE IS A CASE, HOWEVER, IN
WHICH THE 1ST ACTIVE FIELD
WILL BE THE RIM WIDTH.
THIS CASE WILL OCCUR ONLY IF
FROM "HOME" PAGE IS DETECTED
ONLY ONE MEASUREMENT IN-
SIDE THE RIM. THE PROGRAM
WILL AUTOMATICALLY SET TO
"STATIC" BUT IT WILL MAKE IT
POSSIBLE (IN CASE OF ABSENCE
OF EXTERNAL DATA GAUGE) TO
MANUALLY ENTER RIM WIDTH
AND TO QUICKLY SWITCH TO THE
PROGRAM "DYNAMIC".
INSTRUCTION, USE AND
MAINTENANCE MANUAL
G3.140R - GP3.140R - G3.140RS - GP3.140RS
14.5 Wheel balancing screen page descrip-
After executing the spin of the wheel, the monitor dis-
plays a series of important information that helps the
operator in his operations and subsequent choices.
Fig. 46
1 a b
d 5 c 4
KEY
1 – Measures used by the program to perform the
P1 – Weight to be fitted on rim outer side
P2 – Weight to be fitted on rim inner side
2 – Wheel placed to fit the weight on wheel outer
3 – Wheel not placed to fit the weight on wheel
4 – Wheel balancing suggestions
4a – SPLIT Program (Clip weights program) or
4b – SPOKES Program (program with adhesive
4c – ECO-WEIGHT Program with weight value to
4d – STATIC Program
5 – N° user (if selected)
6 – Arrows indicating the weight fitting point with
7 – Wheel repositioning button for weights fitting
8 – Display the actual weight
9 – By pressing the button
tion
3 P2
3 8
spin and detect the values in P1 - P2
side (arrows both green)
inner side (blue/black arrows)
MATCHING Program
weights)
be fitted (if the value is of blue, the machine
advises not to use it)
distance-diameter caliper arm
following page where you can select one of the
programs suggested by the machine.
RAVAGLIOLI S.p.A.
6 P1 2
7 9 2
you will see the