Ravaglioli G3.140R Instruction Manual page 25

1297-M007-1_R
GB
Page 25 of 60
- Bring into contact the weights fitting gripper with the
inner part of the rim (2 contact points) (see Fig. 37)
to select "ALU-S" program.
REPEATEDLY BRINGING THE
GAUGE'S ARM (FIG. 38 REF . 1) IN
CONTACT WITH THE MANDREL
(FIG. 38 REF . 2), THE PROGRAM
WILL CYCLE FROM "ALU-S" TO
"ALU-S1" TO "ALU-S2" THEN RE-
TURNING TO THE BEGINNING.
WHENEVER THE DISTANCE-DI-
AMETER CALIPER AND/OR THE
EXTERNAL DATA GAUGE (GAR306
OR GAR304, SEE FIG. 39) (IF ANY)
IS KEPT IN POSITION FOR A FEW
SECONDS AGAINST THE RIM
(UNTIL THE MACHINE MAKES AN
APPROPRIATE SOUND NOTIFICA-
TION), THE POSITION IS STORED
AND THE VALUES MEASURED IN
THE PRE-ARRANGED FIELDS IN
THE SELECTED WHEEL BALANC-
ING PROGRAM ARE LOADED.
INSTRUCTION, USE AND
MAINTENANCE MANUAL
G3.140R - GP3.140R - G3.140RS - GP3.140RS
- After entering all the required measures, you can spin
the wheel by pressing the button
the protective guard.
• Measuring procedure of electronic RUN-OUT with
the distance-diameter caliper arm.
The electronic RUN-OUT measuring device is useful
to check if the rim has some imperfections.
To access the screen to choose the rim control mode,
proceed as follows:
- from the "Home" page, press the button
(Fig. 40 re. 1) and then the button
Fig. 41 ref. 1).
Fig. 40
Fig. 39
Fig. 41
Width
automatic
measurement
GAR306
Width
automatic
measurement
GAR304
RAVAGLIOLI S.p.A.
1
and closing
(see
1