Advertisement
Assembly Instructions
STEP 5 (optional)
Insert four of the M6x10 Machine Screws into the holes of
the Beams then assemble the Cable Tray as shown in the
picture below.
*Please note that once you install the Cable Tray, the base
width will be locked in that position. If you'd like to adjust
the base width, skip to step 7*
STEP 6
Place the Cable Cover Tray (12) on top of the
Cable as shown in the picture below.
STEP 7
Use 24 of the M6x10 Machine Screws to
attach the Center Rails to the Frames and to
attach the Screen Holders (11).
STEP 8
Use the ST5x20 Wood Screws to attach your two
table tops (sold separately) to the assembled table lift
set. Please ensure this is enough space between the
table tops so they do not over lap one another.
STEP 9
Connect the Cables and attach the Hand Remotes
to the table tops. Position them wherever you want.
6
Advertisement
