.
Assembling the Product
3
3.9.1 Switchgear and SMPS Assembly Installation
Figures may show other assemblies to indicate relative position. Those assemblies will be installed at a
later time.
Important
Attach each Switchgear to its rack frame with four M5 x 10 mm screws. (Torque: 5.1–
6.1 Nm [45–54 in lbs])
Verify that the torque setting is correct.
1. Insert the Switchgear Assembly through the front of the rack as shown in Figure 3-10: Inserting Switchgear
2. After all Switchgear Assemblies are inserted in the rack frames, attach each to the rack frame with four M5 x 10
mm bolts. (Torque: 5.1–6.1 Nm [45–54 in lbs])
22
Figure 3-10: Inserting Switchgear
Figure 3-11: Attaching a Switchgear Assembly to a Rack Frame
ET003222373
English 4/2018. Rev 0.0