.
Assembling the Product
3
4. Insert SMPS Assembly into the rack frames designated for SMPS Assembly as shown in Figure 3-13: Inserting
SMPS Assembly
Important
Attach the inserted SMPS Assemblies to the rack frames by fastening each with four
M5 x 10 mmscrews
Verify that the torque setting is correct.
5. Slide the SMPS Assembly into the rack frame on the shelf designated for the SMPS Assembly as shown below.
6. After all SMPS Assemblies are inserted into the rack frames, attach them to the Rack with screws (Torque: 5.1–6.1
Nm [45–54 in lbs])
7. After each SMPS Assembly is attached to the rack frames, connect the ground cable (Wire Assembly Earth).
24
(Torque: 5.1–6.1 Nm [45–54 in lbs])
Figure 3-13: Inserting SMPS Assembly
Figure 3-14: Attaching the SMPS Assembly
ET003222373
English 4/2018. Rev 0.0