TaiLor Made
Ottobock Microprocessor Knees
The 1T01 TaiLor Made foot has now been approved by Otto Bock
HealthCare Products GmBH for possible combination with the
following knees:
- Ottobock 3B5 Genium® X3
- Ottobock 3B1 Genium®
- Ottobock 3C88/98-3 C-Leg® 4 (restricted to sizes 22 cm – 27 cm)
- Ottobock 3C88/98-2 C-Leg® 3
- Ottobock 3C60 Kenevo®
Use the following steps for properly configuring the Ottobock microprocessor-
controlled knee with the 1T101 foot.
Genium and Genium X3
Special Considerations
- Follow the software prompts for a fitting with a standard Ottobock foot.
X-Soft Software Set-up
- In the Job Specification tab, choose the "Standard" option under Foot Type.
Bench Alignment: Follow the Ottobock C-Leg Bench Alignment recommendations (see below)
Static Alignment: Follow the standard procedure for using the CAA (Computer Assisted Alignment)
in the software.
C-Leg
Special Considerations: Follow the software prompts for a fitting with a standard Ottobock foot.
C-Soft Plus Software Set-up
- In the Job Specification tab, choose the "Standard" option under Foot Type
Bench Alignment: Follow the Ottobock C-Leg Bench Alignment recommendation in the instructions for use
(see below).
Static Alignment: Follow the C-Leg Static Alignment recommendation in the instructions for use
(see below).
Foot Quick Guide for
TM
Note: When using the Tube Adapter Configuration Tool in X Soft with 'Standard'
foot selected, the system height for that particular foot must be manually entered
into the configuration tool.
Note: Do not follow the bench alignment recommendation in X-Soft since this
will be incorrect for the TaiLor Made foot.
Note: When using the Tube Adapter Configuration Tool in X Soft with 'Standard' foot
selected, the system height for that particular foot must be manually entered into the
configuration tool.
Note: There is no selection of the foot type in C-Soft.