MikroTik RouterBOARD 1200 Quick Setup

Route R rBOA ARD 1
Qu uick Setu up Guide
Fi irst use:
Th e RB1200 co omes preinst
ne wer, if your device come
htt tp://wiki.mik krotik.com/w
Th e device doe esn't contain
a d default IP add dress for con
See e this page f or connectio
htt tp://wiki.mik krotik.com/w
Plu ug in the IEC C13 power c
Po owering
Th e device sup pports 100‐24
po wering will v void the war
Bo oting proces ss
Firs st, RouterBOO OT loader is st
ser rial port is set by default to
har rdware (RTS/C CTS) flow cont
net twork. See the e respective s
DH HCP or BOOTP (configurable
pro ovide the add ress of a TFTP
the e User's manu ual for more in
boo ot and the BO OOTP/DHCP an
the em – they mus st be on the s
See e www.routerbo oard.com for mo
200
and War rranty In nformatio
alled with Ro outerOS and d is ready to u
es preinstalle ed with an ea
wiki/Manual: :Upgrading_R
n any configu uration, it mu
nnecting: 192 2.168.88.1 u
on and config guration guid
wiki/Category y:Manual
cable into th e back of the
40V powerin ng at the buil
ranty. Maxim mum power
tarted. It displ lays some use
115200bit/s, 8 data bits, 1 1 stop bit, no p
trol. The load er may be con
section of Use r's manual on
e in loader) pr rotocols allow w the RouterBO
P server to dow wnload an ELF
nformation an nd protocol de
nd TFTP serve ers to the sam me broadcast d
same Ethernet t switch).
ore information. Contact suppor
on
use. RB1200
arlier version n, please upg
RouterOS
ust be config gured prior to
username is a admin and th
des:
e device to p power it on.
lt in PSU. The e device doe esn't support
consumptio n of this dev
eful informatio on on the onb board RS232C
parity. Note th
nfigured to bo oot the system m from the on
n how to confi igure booting
OARD 1200 se
F boot image from. It is esp pecially useful
etails. Note th hat you must c
domain (i.e., t
rt@mikrotik.com m for support qu
is compatib ble with Rout terOS v5 and
grade before e using it:
o use. The Et thernet port
here is no pa assword
t PoE. Using
ice is ~23W
asynchronou us serial port. T
hat the device e does fully im mplement
nboard NAND,
sequence and d other BIOS
eries board to o get an initial
l for software
connect the R RouterBOARD
here must not t be any route
uestions.
d
"Ether 1" ha as
other means s of
The
, and/or from
parameters.
IP address, an nd
installation. S See
you want to
ers between
rev. A ( 6-Jan-2011)