GE SVi 1000 Masonelian Quick Start Manual page 37

2. Connect the 4 - 20 mA input signal and the optional switches or position
retransmit by:
a. Stripping the insulation at the end of both wires 0.43" / 11 mm.
b. Inserting the stripped end of the wires fully in to the appropriate terminal.
Loosen the terminal screw if required to insert the wire.
Refer to the label next to each screw terminal to determine the function of the
terminal and correct polarity (see Figure 19 for 4 - 20 mA connections and
Figure 20 on page 38 for position retransmit).
c. Tightening the terminal screws (to a torque of 5 to 7 lb·in).
Figure 19 Connections to Electronics Module with Switches (via Interface Board)
© 2016 General Electric Company. All rights reserved
. Masoneilan SVi1000 Positioner Quick Start Guide =| 37
Optional Solid
State Switches
4- 20 mA
Input Signal
Ground