Instructions For Webconfig - Lancom 850 UMTS Manual

Table of Contents

Advertisement

3.3

Instructions for WEBconfig

To configure the router with WEBconfig you must know how to address it in
the LAN. The reaction of the devices, as well as their accessibility for configu-
ration via web browser is dependent on whether a DHCP server and a DNS
server are already active in the LAN, and whether these two server processes
exchange the assignment of IP addresses to symbolic names within the LAN
between each other.
After powered on, unconfigured LANCOM devices check first, whether a DHCP
server is already active in the LAN. Dependent on the situation, the device is
able to switch on its own DHCP server or, alternatively, to activate its DHCP
client mode. In this second operating mode, the device itself can obtain an IP
address from a DHCP server already existing in the LAN.
Network without DHCP server
Not for centrally
In a network without DHCP server, unconfigured LANCOM devices activate
managed LANCOM
their own DHCP server service after starting, and assign appropriate IP
Wireless Router or
addresses and gateway information to the other workstations within the LAN,
LANCOM Access
provided that the workstations are set to obtain their IP address automatically
Points
(auto-DHCP). In this constellation, the device can be accessed with any web
browser from each PC with activated auto-DHCP function through the name
LANCOM or by its IP address 172.23.56.254.
If the configuration PC does not obtain its IP address from the LANCOM DHCP
server, figure out the current IP address of this PC (with Start
cmd and command ipconfig at the prompt under Windows 2000 or Windows
XP, with Start
under Windows Me and Windows 9x, or with the command ifconfig on the
console under Linux). In this case, the LANCOM is reachable under the IP
If a LANCOM Wireless Router or LANCOM Access Point is centrally
managed from a LANCOM WLAN Controller, the DHCP mode is swit-
ched from auto-mode to client mode.
http://LANCOM
Execute
cmd and the command winipcfg at the prompt
LANCOM 3850 UMTS
Chapter 3: Basic configuration
http://172.23.56.254
Execute
37

Advertisement

Table of Contents
loading

Table of Contents