Lancom 850 UMTS Manual page 23

Red
Orange/
green
Orange /
red
Status of DSL connections:
DSL
Off
Green
Green
Green
Red
UMTS Status of UMTS connections:
Off
Orange
Orange
Green
Green
Green
Green
Red
Red/
Orange
On (perma- Error establishing the last connection
nently)
In the housing At least one WLAN module is in managed mode and has not
cover; blinking found a WLAN Controller yet. The corresponding WLAN
alternately with module(s) is/are switched off until a WLAN Controller is
the power LED found to supply a configuration, or until being switched
manually into another operating mode.
In the housing At least one WLAN module is in managed mode and has
cover; blinking found a WLAN Controller. However, the WLAN Controller
alternately with cannot assign a configuration because the firmware and/or
the power LED the device's loader version is not compatible with the WLAN
Controller.
No DSL connection
Blinking Establishing the first connection
Flashing Establishing an additional connection
On (perma- At least one logical connection is established
nently)
Blinking/Flas- Data traffic (TX or RX)
hing
No UMTS connection
Flashing Login to the UMTS network active
On (perma- Login to the UMTS network completed
nently)
Blinking Establishing the first connection
Flashing Establishing an additional connection
On (perma- At least one logical connection is established
nently)
Blinking/Flas- Data traffic (TX or RX)
hing
Flickering CRC error
Blinking Hardware error
LANCOM 3850 UMTS
Chapter 2: Installation
23