Table Of Contents - Promac 941A Operating Instructions Manual

Metal lathe

Table of Contents

INTRODUCTION......................................................................................................................4

MAIN PARAMETERS....................................................................................5

SECTION 1: SAFETY...............................................................................................................7

SECTION 2: POWER SUPPLY...............................................................................................9

Availability.................................................................................9

Circuit Requirements....................................................................9

Grounding & Plug Requirements....................................................10

Extension Cords.........................................................................10

SECTION 3: SETUP....................................................................................11

Unpacking.................................................................................11

Inventory.................................................................................11

Clean Up..................................................................................12

Installation Dimensions................................................................12

Check Gearbox Oil.....................................................................12

Open the Cover..........................................................................13

Install belt and Chang speeds.........................................................13

Test Run Lathe...........................................................................14

SECTION 4: OPERATE................................................................................15

General....................................................................................15

Controls....................................................................................15

Removing/Installing Chuck or Faceplate..........................................16

Dead Centers.............................................................................17

Tailstock Positioning....................................................................18

Changing Tool Posts....................................................................18

Cross Slide.................................................................................18

Compound Slide.........................................................................19

Carriage Handwheel....................................................................20

Half Nut Lever...........................................................................20

Carriage/Cross Feed Lever............................................................20

Carriage Lock............................................................................20

Gearbox Levers...........................................................................20

Threads and Change gears............................................................21

Left threads and reverse cutting feed................................................21

Clutch Overload..........................................................................22

SECTION 6: MAINTENANCE........................................................................23

Lubrication...............................................................................23

Ball oilers............................................................................................................23

Feed Rate Gearbox Oil Reservoir....................................................................24

Gibs........................................................................................25

Bearing Preload.........................................................................26

Table of Contents

Table of Contents