Table of Contents
Advertisement
SECTION 5: MAINTENANCE
Lubrication
Your lathe has numerous moving metal-to-
metal contacts that require proper lubrication to
help ensure efficient and long-lasting operation.
Other than the lubrication points covered in this
section, all other bearings are internally
lubricated and sealed at the factory. Simply
leave them alone unless they need to be
replaced.
Before adding lubricant, clean away any debris
and grime from the lubrication point to avoid
contaminating the lubricant and increasing
wear of the moving parts.
DISCONN ECT THE LATHE FROM
POWER BEFORE PERFOR MING LUBRI
CATION !
Note : The change gears and the ball
oilers have the same lubrication
Ball Oilers
Lubricant
Frequency
ISO 68 or
Every 8
Equivalent
Hours
Lubricant
of Operation
Figure 29
Qty
1 Squit
From Oil
Can
22
Figure 30
Figure 31
Figure 32
Advertisement
Table of Contents
