Related Manuals for BRIG Eagle 6
Summary of Contents for BRIG Eagle 6
- Page 1 OWNER'S MANUAL English Rigid Inflatable Boat Eagle 6 MODEL: Design category (2013/53/EU): ISO 6185-3: Type VIII...
-
Page 2: Table Of Contents
SKI MAST STEERING CONSOLE FUEL SYSTEM DRAIN SYSTEM SHOWER KIT WIRING DIAGRAM PREPARATION FOR EXPLOITATION INFLATION/DEFLATION BOAT TUBE STORAGE BATTERY INSTALLATION BOAT TRANSPORTATION BY TRAILER REBOARDING MEANS HOW TO INSTALL SUNDECK MAINTENANCE OPERATING REGULATIONS 2018 — 2 — "BRIG" inflatable boats... - Page 3 CHECK, THAT THE CHECKS HAVE BEEN MADE AND THAT THE PLANTS HAVE BEEN COMPLETED BEFORE DELYVERY. BRIG Ltd declines any responsibility for systems and accessories that have not been installed and checked by expert and authorised personnel. The manual and all its enclosures should be stored carefully, and the manual should always be kept aboard.
- Page 4 Recreational Craft Directive 2013/53/EU Certifying Body: INTERNATIONAL MARINE CERTIFICATION INSTITUTE Rue Abbe Cuypers 3 / B-1040Bruxelles / Belgique Notified Body : 0609 www.imci.org Name of Manufacture: BRIG Ltd. Lozovskaya 88, Dergachy 62303 Kharkovskaya obl. UKRAINE www.brig-ribs.com 2018 — 4 — "BRIG" inflatable boats...
-
Page 5: Danger Levels
Before using your boat, read this MANUAL carefully and ensure that you have understood all the procedures it describes. Before taking command of your boat, be sure to have acquired experience and confidence in its operation. — 5 — EAGLE 6 2378G.01... -
Page 6: Identification Plate
IDENTIFICATION PLATE. Builder's Plate: Boat Design Category Eagle 6 VIII Maximum propulsion according to power rating for the Directive 2013/53/EU boat 2480 1125 Passengers capacity The rated tube pressure value Manufacturer’s recommended maximum load, including the mass of the outboard engine(s) but... -
Page 7: Safety Regulations
(ISO 6185), so always make reference to total maximum transportable weight. The max weight of the installable motors indicates the maximum overall weight applicable on the stern board, including any emergency motors. NEVER exceed the stated value. — 7 — EAGLE 6 2378G.01... -
Page 8: Beaufort Wind Scale
NOTE: The significant wave height is the mean height of the highest one-third of the waves, which approximately corresponds to the wave height estimated by an experienced observer. Some waves will be double this height. 2018 — 8 — "BRIG" inflatable boats... -
Page 9: Remember Fire Danger Always
Extinguisher or any other fire-fighting equipment should be checked periodically and replaced with the same or superior types if expired or inefficient. Equip the boat with fire-fighting equipment before launch and use. — 9 — EAGLE 6 2378G.01... -
Page 10: Technical Specifications
TECHNICAL SPECIFICATIONS. The basic parameters and dimensions of the boat EAGLE 6 comply with the data specified in the following table. All dimensions measurments indicated have a tolerance of +/- 3%, weight measurments indicated have a tolerance of +/- 5%. -
Page 11: Complete Set
COMPLETE SET . The table shows the maximum possible complete set, which may differ from your boat. Description Unit of Eagle 6 measure Inflatable boat pcs. Foot pump pcs. Paddle pcs. Set of spare parts and repair kit: - mooring line - coated fabric for repair 0.06... - Page 12 Description Unit of Eagle 6 measure Mast for navigation lights with installation kit pcs. Mast equipment: Anchor light (white) pcs. Bow step-plate with navigation lights (red and green) pcs. Drain automatic bilge pump pcs. Towing eye pcs. Soft back of stern-part seat pcs.
-
Page 13: The Main Dimensions
THE MAIN DIMENSIONS. The main dimensions of Eagle 6 have tolerance of +/- 3%. The length of the boat with the engine can vary depending on the model of the engine and the angle of its deviation. (See Fig. D0) 6.5 m... - Page 14 2018 — 14 — "BRIG" inflatable boats...
-
Page 15: Boat Design
BOAT DESIGN of EAGLE 6 (fig.D1). 1 — Rigid hull 2 — Reinforced buoyancy tube 3 — Steering console 4 — Inflate valves 5 — Drain valves 6 — Bilge valve 7 — Bow plate 8 — Lifting eyes 9 — Bow removable curshion 10 —... -
Page 16: Rigid Hull
— outer neck for water fill (15); — inspection hatch (16); — two stern cleats (17); The fore part of the cockpit may be simply converted into the sundeck by means of false decks and soft cushions. 2018 — 16 — "BRIG" inflatable boats... -
Page 17: Reinforced Buoyancy Tube
Also there are the following elements fitted on the tube (Fig. D1): — doubled rubbing strake (3, Fig.D1); — safety handles (4, Fig.D1); — bow step-plate with a special moulded antiskid coating (6, Fig.D1). — 17 — EAGLE 6 2378G.01... -
Page 18: Ski Mast
— place for installation of analog or/and digital devices, (6); — socket 12V (7); — niche for small items (8); — compass (9); — electric horn (10); — steering wheel (11); — fuse holding box (located inside the console) (12). 2018 — 18 — "BRIG" inflatable boats... - Page 19 Fuse holding box with warning lights Always check the fuse. Burning red LED display on the fuse box warns of HORN faulty fuse Always keep a spare set the fuse in an easily-accessible location. — 19 — EAGLE 6 2378G.01...
-
Page 20: Fuel System
Do not smoke when refueling. Stop the engine and switch off any electric equipments before refueling. It is dangerous to pretend to be an expert. This may cause damages. Refer to expert and authorized specialists for all types of maintenance and repair. 2018 — 20 — "BRIG" inflatable boats... -
Page 21: Drain System
Do not dispose bulky objects in front of the cockpit drain sockets. Do not modify drain systems. Before navigation check the drain valves. Never locate heavy objects on the drain hoses. It will be cause of bucking, distortions and damages. — 21 — EAGLE 6 2378G.01... - Page 22 Never locate heavy objects on the d r a i n h o s e s . I t w i l l b e c a u s e o f bucking, distortions and damages. 2018 — 22 — "BRIG" inflatable boats...
-
Page 23: Shower Kit
Always drain the water out from the water tank and all hoses, if it is likely lowering the ambient temperature to negative values. This way you prevent damage to the tank and hoses freezing water in them — 23 — EAGLE 6 2378G.01... -
Page 24: Wiring Diagram
9 — Electric horn. 18 — Switch with automatic circuit breaker — shower pump. 10 — Fuel level gauge. 19 — Switch with automatic circuit breaker — electric horn. 11 — Fuel level meter 2018 — 24 — "BRIG" inflatable boats... -
Page 25: Preparation For Exploitation
Check the tube pressure before every navigation. The rated pressure value is 0.15 bar (2.2 psi). If the tube pressure more than nominal, deflate the tube slightly. Boat exploitation with board pressure more than nominal decreases boat service life. — 25 — EAGLE 6 2378G.01... -
Page 26: Storage Battery Installation
It is possible to install the boat on several reference points. Thereby the point of support (1) must be an obligatory, and the point of support (2), (3), (4) must be an additional. Lateral roller supports can be used only with a view of prevention from tipping. 2018 — 26 — "BRIG" inflatable boats... - Page 27 (keel line) Maximum transportable mass I n o r d e r t o a v o i d t h e h u l l Eagle 6 – 1070 kg damage, install the boat on the stated areas only.
-
Page 28: Reboarding Means
If you are in the water, and the ladder is folded, you can lay out it and return onboard. The ladder can be fixed with Velcro. Just unclip it.(fig.D12) Be careful - the rotating propeller on the engine 2018 — 28 — "BRIG" inflatable boats... -
Page 29: How To Install Sundeck
— Further, please place two soft cushions onto the false decks and fasten them with the help of press-buttons (Fig. A1d). front seat of the steering console false deck boards Soft cushion Front locker removable cushions Always check fixation of the sundeck cushions. — 29 — EAGLE 6 2378G.01... -
Page 30: Maintenance
0°C, it must be kept at a temperature above +15°C at least for 1 hour before to be unpacked and unfolded. For small repair boat tube use the coated fabric and glue set from the complete set. 2018 — 30 — "BRIG" inflatable boats... -
Page 31: Operating Regulations
This arrangement will enable you to avoid any traumas and to reach the boat. Take all possible precautions against penetration of fuel, oil or electrolyte from the storage battery into the inflatable boat. If it does happen wash thoroughly the fouled spots with water. — 31 — EAGLE 6 2378G.01... - Page 32 Despite the strong shell of the boat we recommend carefully handle and operate with sharp and pricking objects which you have on board . It concerns, for example, a knife blade, fish-hook point, etc. 2018 — 32 — "BRIG" inflatable boats...
- Page 33 Reduce the speed and shift your body to the undamaged part of the boat. Observe changes in stability. After that, immediately head for the nearest shore. To prevent penetration of water into the boat, pull the shell of the damaged air chambers upwards. — 33 — EAGLE 6 2378G.01...
- Page 34 When the boat is fitted with an engine with maximum recommended power it must be use with extreme care. This application is directed at experienced users using their boats for very specific purposes. 2018 — 34 — "BRIG" inflatable boats...
- Page 35 If the liferaft is contained in a soft bag then it may be stowed in a compartment but shall be readily available for use. Liferaft not supplied by the manufacturer and must be installed by owner. — 35 — EAGLE 6 2378G.01...
- Page 36 Eagle 6 MODEL SERIAL No. UA-QRK Date of manufacture Quality inspection stamp NOTE: The inflatable boat was delivered with the following equipment installed: Stamp and signature 1.Fuel tank 5.Steering system Stamp and signature Stamp and signature 2.Electric system 6.Engine power system Stamp and signature 7.Engine installation, test and...