Table of Contents
Related Manuals for BRIG FALCON F330L
Summary of Contents for BRIG FALCON F330L
- Page 1 OWNER'S MANUAL English "FALCON" SERIES: F300, F330, F360 MODELS: (F300H*, F330H*, F360H*) Deluxe version: F300L, F330L, F360L Sport version: F300S, F330S, F360S H* – boats tube made of HYPALON (Du Pont registered trademark) coated fabrics.
-
Page 2: Table Of Contents
CHECK THAT THE CHECKS HAVE BEEN MADE AND THAT THEPLANTS HAVE BEEN COPLETED BEFORE DELYVERY. BRIG Ltd declines any responsibility for systems and accessories that have not been installed and checked by expert and authorithed personnel. The manual and all its enclosures should be stored carefully, and the manual should always be kept aboard. - Page 3 The CE marking indicates that the inflatable boat was built in compliance with the Directive 94/25/EC applied to pleasure craft Certifying Body: BUREAU VERITAS S.A. 92077 Paris La Defense Cedex Name of Manufacture: BRIG Ltd. Lozovskaya 88, Dergachy 62303 Kharkovskaya obl. UKRAINE www.brig.ua — 3 —...
-
Page 4: Danger Levels
DANGER LEVELS. The manual contains warnings, identified as follows: A note like this indicates that there is serious riskthat is likely to cause death or permanant serious injury, if appropriate precautions are not taken. A note like this indicates the existence of risk that may cause death or injury, if appropriate precautions are not taken. -
Page 5: Identification Plate
IDENTIFICATION PLATE. Builder's Plate: Plate with identification number: UA-QRK12345A000 It is fundamental for the plates to be aboard the boat, since they are only form of recogmition and identification. Without them the boat does not comply with the legislation in effect. The plates must never be removed. Any tampering or removal not authorised by the manufacturer is the full responsebility of the owner. -
Page 6: Safety Regulations
SAFETY REGULATIONS. This manual contains recommendations and basic rules of conduct for using the boat in complete safety.Although it is not possible to offer safety information for all potential situations, in general it is recommended that you: Regularly check which safety requirements are in force. Maintain the boat and the onboard plants in optimum condition. -
Page 7: Beaufort Wind Scale And Corresponding State Of The Sea, After Few Hours Of Wind, Away From The Coast
BEAUFORT Wind Scale and Corresponding State of the Sea, After Few Hours of Wind, Away From the Coast. State of the sea Force Denomination Knots Km/h m/sec and wave height in meters Calm <1 <1 0-0.2 Calm Light Air 0.3-1.5 Calm Light Breeze 6-11... -
Page 8: Remember Fire Danger Always
REMEMBER FIRE DANGER ALWAYS. Fire may be caused by: Crew nagligence when smoking, the presence aboard of flammable liquids, electrical contacts, propulsion motor, errors in fueling, or if maintenance has not been performed as required. Once again, it is important that the crew behave correctly and that the boat is kept in order to avoid serious damage to it and to persons. Easly flammable products must not be kept aboard. -
Page 9: Technical Specifications
TECHNICAL SPECIFICATIONS. "BRIG" inflatable boat of the "FALCON" series fulfills the requirements of conformity to the essential requirements of the Directive 94/25/EC and ISO 6185-3. The basic parameters and dimensions of the boats comply with the data specified in the following table:... -
Page 10: Complete Set For Deluxe And Sport Versions
COMPLETE SET for Deluxe and Sport versions. F300L F300S F330L F330S F360L F360S Parameter Unit Package No1 1. Inflatable boat 2. Foot pump 3. Paddle 4. Set of spare parts and repair kit: –mooring line 0.01 0.01 0.01 0.01 0.01 0.01 –coated fabric for repair –glue set for repair... -
Page 11: Package Dimensions
5 - Sport console 6 - Lifting bow eye 7 - Rowlock 8 - Lifeline 9 - Lifeline holder 10 - "BRIG" label 11 - Rubbing strake 12 - Carrying handle 13 - Oar stowage 14 - Oar 15 - Towing bow eye Fig.1... -
Page 12: Steering Console
Steering console Tender Luxe TL-01 is intended for mounting steering system and remote control system. The console TL-01 may be installed on the BRIG boats F300L, F330L and F360L. The Steering console TL-01 consists of the following main components (Fig.3): •... - Page 13 In order to install the console to the BRIG boat perform the next operations (Fig. 4): • hinge out the overhead console part; • fix the console by means of the bolt M8x25 and washers to the deck boat; • replace the console overhead part;...
-
Page 14: Tender Container For Deluxe Version
Fig. 6 Tender Container TC-01 Tender Container TC-01 Bottom view n order to install the container to the BRIG boat perform the next operations (see Fig.6 and Fig. 7): • hinge out the seat; • fix the cntainer by means of the bolt M8x25 and washers to the deck boat;... -
Page 15: Steering Console For Sport Version
B has been designed for the installation of the standard fuel tank (12L max). In order to install the console to the BRIG boat per- form the next operations (Fig. 8): • disconnect the upper removable part with seat;... -
Page 16: Inflation/Deflation Boat Tube
Inflation/deflation boat tube. The inflation valve (see Fig.9) has two positions of sliding part A corresponding to its two conditions (modes): – sliding part A is withdrawn - operation condition of the valve (compartment air filling mode); – sliding part A is recessed - valve in condition "OPEN" (compartment air discharge mode). -
Page 17: Preparation For Exploitation
PREPARATION FOR EXPLOITATION. In order to set the boat in the operation condition perform as follows: Unfold the inflatable balloon. Apply the foot pump to fill the afterbody of the compartments with air to the pressure being slightly below its rated value (the balloon will be completely straightened). -
Page 18: Remuvable Fuel Tank
REMUVABLE FUEL TANK. The recommended posotion on board for install of remuvable fuel tank is following: - for DeLuxe version - inside the Tender console (fuel tank 25L max) (see Fig.11) - for Sport version - on the rear part of the boat (see. Fig.12) or inside the Sport console (but fuel tank 12L max only). For DeLuxe version For Sport version REMUVABLE... -
Page 19: Maintenance
MAINTENANCE. Main conditions of long service life is right and careful servicing. Avoid excessive increasing of pressure in the board, especially from heating by the sun rays. After exploitation take off sand and dirt from boat surface, and carefully dry it. Avoid the water getting into the chambers. - Page 20 IT IS FORBIDDEN to bring the tube pressure up to the value exceeding the rated one (0.15 bar(2.2pci)) IT IS STRICTLY FORBIDDEN to drag the boat across a rough surface. For each particular water area the local shipping regulations are in force. You may apply for information to the appropriate water transport and shipping directorate, as well as to the water police.
- Page 21 All passengers should put on life-saving jackets CHILDREN and non-swimmers MUST BE A FLOATATION DEVICE AT ALL TIMES. Always check that floatation devices for children are of the rigt size and that they are operational. Arrange the cargo to be carried uniformly inside the boat, all items being reliable secured on the bottom of the boat.
- Page 22 Towing At towing the towing rope length should not be at least 3 lengths of the boat. The steersman of the towed boat should be assisted by another crew member to monitor the process of towing. In this case, certain communication gestures should be agreed upon beforehand. The rope being secured to both boats in a manner ensuring its immediately, single-motion release.
- Page 23 In emergency stay in boat In any unexpected situation (engine failure, boat damage, etc.) do not ever leave the boat provided it is still afloat. Even if you believe that the shore is just nearby stay in the boat, since you will be looked for in this particular place and, most probably, will be found. Should the boat become partially flooded throw heavy objects (batteries, fuel tank, engine) overboard to ensure additional floatability.
- Page 24 inflatable boats MODEL SERIAL No. UA-QRK Date of manufacture Quality inspection stamp NOTE: The inflatable boat was delivered with the following equipment installed: 1.Fuel tank 4.Steering system Stamp and signature Stamp and signature 2.Electric system 5.Engine power system Stamp and signature Stamp and signature 6.Engine installation, test and Stamp and signature...