Table of Contents
Advertisement
6.3
SENSOR AIR FILTER
Potential hazardous atmosphere and low oxygen levels inside the container, ventilate before
entering. Stay away from doors while venting. Refer to
Before servicing unit, make sure the Start-Stop switch (ST) is in the OFF position. Unit circuit
breaker (CB-1) and external power sources are turned OFF and tagged to prevent accidental
energizing of circuits.
6.3.1
Removing the Sensor Air Filter Element
When replacing the Sensor Air Filter element it can be accessed in two ways: through the left-hand side evaporator
access panel or through the inside of the container by removing the upper back panel
tion 6.6
for procedures to remove and install the left access panel.
Figure 6.4 Left Access Panel and Back Panel (Inside of Container)
Figure 6.3 CO
/O
Assembly
2
2
CO
/O
Inlet
2
2
WARNING
!
Section
WARNING
!
Left Access Panel
6–3
O
Amplifier
2
CO
CO
Sensor
2
Sensor Air Filter
4.7.
(Figure
Back Panel
/O
Outlet
2
2
O
Sensor
2
6.4). Refer to
Sec-
T-366
Advertisement
Table of Contents
Need help?
Do you have a question about the XtendFRESH and is the answer not in the manual?