Hw-Module Profile Qos Hqos-Enable - Cisco NCS 540 Series Routers Command Reference Manual

hw-module profile qos hqos-enable

hw-module profile qos hqos-enable
To enable H-QoS profile, use the hw-module profile qos hqos-enable command in XR Config mode. To
remove the H-QoS profile, use the no form of the command.
hw-module profile qos hqos-enable
no hw-module profile qos hqos-enable
This command has no keywords or arguments.
Syntax Description
H-QoS is disabled by default.
Command Default
XR Config mode
Command Modes
Command History
Release
Release
6.3.1
After enabling H-QoS profile, the router must be reloaded.
Usage Guidelines
Task ID
Task
ID
qos
The following example shows how to enable the H-QoS profile on the router.
RP/0/RP0/CPU0:router#config
RP/0/RP0/CPU0:router(config)# hw-module profile qos hqos-enable
RP/0/RP0/CPU0:router(config)# commit
RP/0/RP0/CPU0:router# reload
Modular QoS Command Reference for Cisco NCS 5500 Series and Cisco NCS 540 Series Routers
76
Modification
This command was introduced.
Operation
read,
write
Hierarchical Modular QoS Commands