Installing The Stopper Guide (Option); Installing The Stopper Guide (To The Finisher Without The Multi Job Tray) - Olivetti DF-650 Service Manual

1-2-5

Installing the stopper guide (option)

• Before installing the stopper guide, press the Power key on the operation panel to off. Make sure that the Power
lamp is off before turning off the main power switch. And then unplug the power cable from the wall outlet.
Turning off the main power switch before pressing the Power key to off may cause damage to the equipped hard
disk.

(1) Installing the stopper guide (To the finisher without the multi job tray)

Procedure
1. Secure the stopper assembly to the finisher
sub tray with three screws (M3 × 8 tap tight
P screw).
* The installation position varies from the inch
specification and metric specification. Make
sure to adjust the position for the inch speci-
fication to the mark of (I) and the position for
the metric specification to the mark of (C).
2. After cleaning with rubbing alcohol, affix the
appropriate operation label (Inch or metric)
to the finisher as indicated.
Y104371-8
M3 x 8 tap tight P screw
Stopper assembly
Mark
(Metric) (Inch)
Installation position
Service Manual
Figure 1-2-52
Operation label
5 to 10 mm
Figure 1-2-53
3H3-2.0
Sub tray
1-2-21