Table of Contents
Advertisement
1-2-2
Installing the centerfold unit (option)
•
When installing the centerfold unit and multi job tray as a set, first install the centerfold unit and then the multi job
tray.
•
Before installing the centerfold unit, press the Power key on the operation panel to off. Make sure that the Power
lamp is off before turning off the main power switch. And then unplug the power cable from the wall outlet.
Turning off the main power switch before pressing the Power key to off may cause damage to the equipped hard
disk.
Procedure
* When unpacking or installing, hold the cen-
terfold unit by a indicated in the illustration.
Do not hold it by b at the center of the unit.
1. Remove the four screws locking down the
guide plate followed by the plate.
2. Remove the left lower shaft from the finisher
side plate.
3. Open the front cover. Remove the screw
locking down the retainer followed by the
retainer.
4. While keeping the front cover perpendicular,
detach the cover by raising it vertically in the
direction of the arrow.
Y104371-8
b
a
Guide plate
Screws
Front cover
Service Manual
a
Figure 1-2-5
Left lower shaft
Screws
Figure 1-2-6
Retainer
Screw
Figure 1-2-7
3H3-2.0
1-2-3
Advertisement
Chapters
Table of Contents
