Correcting Centerfold-Stapling - Olivetti DF-650 Service Manual

(2) Correcting centerfold-stapling

Follow the below procedure when the stapling position is off from the center when the machine is in the stitching copy
mode.
Procedure
Start
Set the machine to the stitching copy
mode and make a test copy. Use
paper of below sizes.
1
A4R, B4R, A3R, 8 / " x 11", 11" x 17"
2
Unfold the copied paper that has been
center-stapled, with the inside faced
down as shown in figure 1-5-5. Check
that the paper is stapled at the center.
Enter the maintenance mode.
Enter 248 using the numeric keys.
Press the start key.
Select SADDLE STAPLE ADJUST.
Select paper size.
1
A4R, B4R, A3R, 8 / " x 11", 11" x 17"
2
Staples are off
toward the paper eject side
(sample 1).
No
Staples are off
toward the paper feed side
(sample 2).
No
Press the stop/clear key.
Exit the maintenance mode.
End
Y104371-8
Exit the maintenance mode.
Press the stop/clear key.
Press the start key to store
the setting value.
Yes
Press the cursor down key
to decrease the setting value.
Yes
Press the cursor up key
to increase the setting value.
Setting range: -10 to +10
Initial value: 0
Changing the value by 1 changes the position of the
stapling by approximately 0.6 mm (reference value).
Increasing the setting value moves the stapling
position toward the paper eject side. Decreasing it
moves the stapling position toward the paper feed
side.
Service Manual
Figure 1-5-5
Sample 1
Figure 1-5-6
3H3
Sample 2
1-5-3