Advertisement
Available languages
Available languages
Attention!
Only use original EIBENSTOCK drill bits.
They were especially developed for the END 712 P, have a high
concentricity and work very effectively.
In case of using other drill bits, we cannot assume any liability!
Safety Instructions
Safe work with this machine is only possible if you read
this operating instruction completely and follow them
strictly.
Additionally, the general safety instructions of the leaflet
supplied with the tool must be observed. Prior to the first
use, the user should absolve a practical training.
If the connection cable gets damaged or cut during use, do
not touch it, but immediately pull the plug out of the socket,
Never use the tool with a damaged connection cable.
When drilling in ceilings or walls make sure you will not cut
through electrical mains, gas or water pipes. Use metal
detection systems if needed.
Before you start working, consult a statics expert to determine
the exact drilling position.
The tool must neither be wet nor used in humid environment.
Do not use the tool near explosive materials.
Do not work on a ladder.
Do not work with materials containing asbestos
Modifications of the tools are prohibited. Pull the plug out of the socket
and make sure is switched off when the machine is not under
supervision, e.g. in case of putting up and stripping down, in case of
voltage drop or when fixing or mounting an accessory.
While working, lead the line cord or extension cord to the back away
from the tool.
Switch the machine off if it stops for whatever reason. This way you
avoid that it starts suddenly and not under supervision.
After an interruption of work the machine should only be switched on
again if the drill bit can be turned easily.
Do not use the machine when one part of the housing is damaged or in
case of damages on the switch, cable or plug.
Electric tools have to be inspected by a specialist in regular intervals.
When using the machine, no cooling water is allowed to get into the
motor and the electric mounting parts, no matter in which position you
work.
12
Advertisement
