Table of Contents
Advertisement
6. Re-start the transmitter by pressing the START buttons
7 and 8 for at least 1 second.
3.6 LATCHING RELAY FUNCTION
In some Operating Modes you can assign a latching function
to certain relays (see description of Operating Modes). Latching
means that the relay is activated every time a button is pressed,
but remains active until the button is pressed again. You can
set this on the receiver using the FUNCTION button and the
SELECT button.
1. Use the FUNCTION button to switch between the 3 function LEDs:
1.
the red CODE STORING LED
2.
the yellow LATCH LED
3.
the green INTERLOCKING LED
2. Stop at the yellow LATCH LED and select it by using the
SELECT button. The yellow LATCH LED will go out. The red
LED above relay 4 will light up.
3. Use the SELECT button to select the relay that you want
to assign a latching function. Press the FUNCTION button to
light up the yellow LATCH LED. If the yellow LATCH LED is
already lit and the red LED above a relay lights up, this relay has
already been assigned a latching function. To remove the latching
function from a relay, press the FUNCTION button once, so
that the yellow LATCH LED goes out.
4. To assign latching to more relays, use the SELECT button to
select the next relay that you want to assign a latching function
to. The receiver will exit the code storing mode after 10
seconds idling.
7
8
7
Receiver
switch
1
2 3
F
S
S
F
F
S
Hide quick links:
Advertisement
Table of Contents
