Safety Device For Broken Saw Blade; Clamping Vise Position Locking Lever; Miter Angle Adjustment - Jet Elite EHB-1018VM Operating Instructions And Parts Manual

12.12 SAFETY DEVICE FOR BROKEN SAW
BLADE
When the saw blade breaks during operation, the limit
switch shown in Fig. 16, will automatically shut the
machine off.
12.13 CLAMPING VISE POSITION
LOCKING LEVER
Due to the mitering function of this saw, the vise can be
moved fore and aft. Make sure to tighten both workpiece
levers (A) in Fig. 17, before clamping the workpiece.
A
EHB-1018VM | EHB-1018VMH

12.14 MITER ANGLE ADJUSTMENT

In order to use the mitering function of this saw, fi rst you
must release the tension on lever (A) Fig. 18 by pulling
the lever up. Then remove the 90 deg pin (A) Fig. 19 to
allow the frame to swing. Set the indicator (B) Fig. 19 to
the desired angle on the scale (C) Fig. 19. After the proper
angle has been set, push the lever down to hold the saw
in place. if the lever does not adequately hold the saw,
the tension can be adjusted by tightening the bolt (B)
under the lever.
A
Fig. 16
C
Fig. 17
B
Fig. 18
B
A
Fig. 19
13