No Network Connection; No Ip Address; No Internet Found; Set-Up Timed Out - Danfoss DBR Installation Manual

Warnings (continued)
No Network
Connection
No IP
Address
No Internet
Found
Set-up Timed
Out
Software
Update
Failed
28
If the TPOne fails to find the home router, then this
warning will be shown. The WiFi signal may be
obstructed or the TPOne-S may be out of range
of the DBR. Where possible move the router or
TPOne-S and re-try WiFi Setup.
If WiFi has previously been set and working and
this warning is shown, where possible move the
router or TPOne-S and the TPOne-S will re-connect
to the router when in range and obstruction free.
Important Note: Ensure that there are no large
metal objects, such as boiler cases, other large
appliances or mirrors in line of site between the
TPOne-S and home router as these may prevent
connection
If the TPOne-S is connected to the home router
but it is unable to obtain a valid IP address this
warning will be shown.
If the TPOne-S has a good connection the home
router but the home router has no internet
connection, then this warning will show
During WiFi setup the TPOne will wait 2 minutes
for a valid mobile device connection. If this
time is exceeded without valid connection, then
this warning will show and WiFi setup will need
repeating.
Automatic software updates will be performed
when the TPOne-S is connected to the Internet. If
an update fails to load correctly, then this warning
will be shown and control of the heating may be
stopped. To reset, power to the TPOne-S must be
removed for minimum 30secs and then re-applied.
TPOne-S