PTI security systems Falcon XT Installation Manual page 24

For RS232 connections (up to 50 feet):
1
RS232 cables for connection of the FalconXT to the StorLogix™ computer are available as
an accessory from PTI Security Systems.
2
Connect the end marked 'Controller' to the RS232C port located on the bottom middle of
the controller circuit board.
3
If needed, run the cable through conduit to the control software computer. Note: Unplug
the connectors from this cable to allow the cable to be pulled through the conduit.
4
Connect the end marked 'PC' to the RS232 port located on the back of the computer.
For Direct Ethernet connections:
1
Use an Ethernet cable with CAT5 Twisted Pair Network cable. Connect one to the
Ethernet port in the bottom right hand corner of the controller circuit board
2
If needed, run the cable through conduit to the control software computer.
3
Connect the other end to the Ethernet port located on the back of the computer.
20 114A3866.C.05 Revised 7-2017