Removing The Interference Filter - Whirlpool 4.3 CU FT Service Manual

COMPONENT ACCESS
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or
electrical shock.
To Remove the Interference Filter
1. Unplug dryer or disconnect power.
2. Perform the procedure on page 4-9, "Remove the Top
Panel" prior to performing the following steps.
3. Remove the harnesses from the Interference Filter (see
Figure 1).
Interference
Filter
4. Use a T20 Torx driver to remove the two (2) screws
securing the Interference Filter to the rear panel. See
Figure 2.
4-10 Whirlpool Compact Heat Pump Dryer
n

Removing the Interference Filter

Black Wire
L1 Top
Red Wire
L2 Bottom
Figure 1
5. Slide the Interference Filter horizontally to release the
filter from back panel. See Figure 2.
Remove 2
T20 Screws
Slide filter to remove
NOTE: When reinstalling the filter, the black wire is on top
and the red wire is on the bottom (see Figure 1).
Figure 2