Whirlpool 4.3 CU FT Service Manual page 65

12. Use a T20 Torx driver to remove the two (2) screws
securing the access cover bracket to the back panel (as
illustrated in Figure 4). Remove cover bracket and set aside.
13. Remove the plastic access cover and set aside (see Figure
5).
Access
Cover
Removing the Back Panel (continued)
Figure 4
Figure 5
14. Use a T20 Torx driver to remove the ten (10) screws
securing heat channel cover to the back panel (as
illustrated in Figure 6). Remove the heat channel and set
aside.
15. Use a T20 Torx driver to remove the three (3) screws
securing the rear panel to the base assembly (as
illustrated in Figure 7). Remove rear panel from base
assembly.
16. Reverse procedure to reinstall the rear panel assembly.
Whirlpool Compact Heat Pump Dryer
COMPONENT ACCESS
Figure 6
Figure 7
4-21
n