Test #5A: Adjusting Customer-Focused Dryness Level - Whirlpool 4.3 CU FT Service Manual

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or
electrical shock.
For Service Technician Use Only
TEST #5a: Adjusting Customer-Focused
Dryness Level
NOTE: If the customer complains about the clothes being less
dry or more dry than desired and the moisture sensor passes
TEST #5: Moisture Sensor, step 2, the total dry time can be
lengthened or shortened by changing the Customer-Focused
Dryness Level from "3" (factory default) to a "2" (15% less
drying time), "1" (30% less drying time), "4" (15% more drying
time), or "5" (30% more drying time) auto cycle.
1. Press POWER, then press and hold the PROGRAM button
as the dryer counts down "3-2-1" before displaying the
current dryness level setting on the 7-segment display.
The factory default value is "3".
2. Turning the cycle selector knob counterclockwise reduces
the dryness level setting number. Turning the cycle
selector knob clockwise increases the dryness level setting
number. The new setting is displayed in the 7-segment
display.
3. With the display showing the desired dryness level setting,
press the cycle selector knob to save the setting and exit
to standby mode. The result will be stored in EEPROM of
the ACU and will be retained after a power loss.
NOTE: If a button other than the cycle selector knob
is pressed, the dryness setting is reverted back to its
previous setting.
4. Press the POWER button at any time to exit from this
mode.
Whirlpool Compact Heat Pump Dryer
COMPONENT TESTING
n
3-13