Grouping St80 Maxiview Instruments - Raymarine SeaTalk Owner's Handbook Manual

81073_6.book Page 12 Thursday, March 2, 2006 2:39 PM
12
8. When all groups have been defined and all Remote Keypads allocated, simul-
taneously press the middle two
return to group setup mode, then simultaneously press the middle two
keys for a further 2 seconds to return to normal operation.

4.3 Grouping ST80 MaxiView instruments

To define a group of ST80 MaxiView instruments:
1. At any Remote Keypad, press and hold the upper
onds. All the ST80 MaxiView instruments enter group setup mode. On one of
the instruments, the display will change to reverse video and the cursor will
flash.
2. Select the first instrument in the group using the
3. Referring to the following illustration, use the appropriate keys to allocate a
group letter and sequence number to the selected instrument. When the
instrument has been properly identified, it should display its group letter and
sequence number, e.g. J2.
Select either:
group setup or
sequence number setup
(toggle action)
Note: In group setup mode, all ST80 MaxiView instruments are selectable.
4. Press
step 3.
5. Repeat the procedure in steps 3 and 4 until all instruments in the group have
been identified.
If you have more than eight ST80 MaxiView instruments, a second group, operated
Note:
by another remote keypad, must be created. The identification code for additional keypads
and instruments would, for example, be K1, K2 etc.
SeaTalk Remote Keypad Owner's Handbook
keys of the bottom row for 1 second, to
Select the required MaxiView instrument
Press to set the identity you want, either:
J to Q for group identity, or
1 to 8 for instrument sequence number
the key to select another instrument and repeat the procedure in
and keys for 4 sec-
and keys.
D2359-2