Raymarine SeaTalk Owner's Handbook Manual page 23

81073_6.book Page 11 Thursday, March 2, 2006 2:39 PM
Chapter 4: Setup
4. Press the
step 3.
5. Repeat the procedure in steps 3 and 4 until all instruments in the group have
been identified.
If you have more than eight standard instruments, a second group, operated by an-
Note:
other Remote Keypad, must be created. The identification code for additional Keypads and
instruments would for example, be B1, B2 etc.
6. Assign a Remote Keypad to the required group as follows:
i. Use the
ii. Press the
Typical ST60 digital
Group setup indications - allocating keypad
iii. At the Remote Keypad, press any one of the keys dedicated to the stan-
7. If you are creating more than one group, repeat the procedures described in
steps 2 to 6.
key to select another instrument and repeat the procedure in
or key to select any instrument in the required group.
and keys together for 1 second. Depending on the type
of instruments you are grouping, the following messages are displayed
on the instruments with the same group letter.
Typical ST80 digital
Typical ST60 analogue
dard instruments, to assign the Remote Keypad to the selected instru-
ment group.
Typical ST80 analogue
ST60 Tridata
D2784-3
11