Auto Arm / Disarm; Delay Settings; Time Settings - Chuango H4 PLUS User Manual

Gsm/wifi smart home system
Hide thumbs Also See for H4 PLUS:
Table of Contents

Advertisement

Auto Arm / Disarm

The system can be programmed to automatically arm, home arm and disarm the
panel at predefined times by following the steps below:
1. Slide the switch to the "on" position to activate the setting.
2. Select a status (Arm / Disarm / Home Mode).
3. Select the activation time.
4. Select the days.

Delay Settings

27
Exit Delay Setting
Set a time delay and turn on/off a reminder tone. During the delay you can exit your
property without triggering an alarm.
Entry Delay Setting
You can install a door contact on your entrance door and change its zone mode to
Delay Zone, and then set a time delay. During the delay you can enter your property
(door contact is triggered) and disarm your system.(for zone setting, please refer to
page 25).

Time Settings

Synchronize Time
This setting enables you to automatically synchronize the time on your smartphone
with the time on your hub. This will ensure that you have the proper timestamp
included on any notifications you receive from the hub.
When motion is detected, you will receive a push notification: (for example) Activity
detected by [PIR Sensor 01] at 08:20:00 GMT+2 Or Activity detected by [PIR Sensor
01] at 07:20:00 GMT+1 DST during Daylight Saving Time.
Date Format
This setting enables you to change the format of the date shown on your app.
28

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the H4 PLUS and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents