Table of Contents
Advertisement
Installation Instructions
Cut out the work surface according to the sizes shown
in the drawing.
For the purpose of installation and use, a minimum of
50mm space shall be preserved around the hole. Be
sure the thickness of the work surface is at least 30mm.
Please select heat-resistant work surface material to
avoid damage caused by the heat radiation from the
hotplate. As shown below:
L (mm)
W (mm) H (mm) D (mm) A (mm) B (mm)
590
520
64
Please ensure the Induction cooker hob is well
ventilated and the air inlet and outlet are not blocked.
Ensure the induction cooker hob is in a good working
state. As shown below.
Note: The safety distance between the hotplate and the
cupboard above the hotplate should be at least 760mm.
A (mm)
B (mm)
C (mm)
760
50 min.
20 min.
60
560
490
D
E
Air intake
Air exit 5mm
Before you install the hob, make sure that:
• The work surface is square and level, and space
requirements have been adhered to
• The work surface is made of a heat-resistant material
• If the hob is installed above an oven, the oven has a
built-in cooling fan
• The installation will comply with all clearance
requirements and applicable standards and
regulations
• A suitable isolating switch providing full
disconnection from the mains power supply is
incorporated in the permanent wiring, mounted and
positioned to comply with the local wiring rules and
regulations.
The isolating switch must be of an approved type and
provide a 3mm air gap contact separation in all poles
(or in all active [phase] conductors if the local wiring
rules allow for this variation of the requirements):
• The isolating switch will be easily accessible to the
customer with the hob installed
• You consult local building authorities and by-laws if
in doubt regarding installation
• You use heat-resistant and easy-to-clean finishes
(such as ceramic tiles) for the wall surfaces
surrounding the hob.
X (mm)
50 min.
When you have installed the hob, make sure that:
• The power supply cable is not accessible through
cupboard doors or drawers
• There is adequate flow of fresh air from outside the
cabinetry to the base of the hob
• If the hob is installed above a drawer or cupboard
space, a thermal protection barrier is installed below
the base of the hob
• The isolating switch is easily accessible by the
customer
Before locating the fixing brackets
The unit should be placed on a stable, smooth surface
(use the packaging). Do not apply force onto the
controls protruding from the hob.
14
Advertisement
Table of Contents
