Table of Contents
Advertisement
Installation Instructions Continued
Adjusting the bracket position
Fix the hob on the work surface by screw 2 brackets on
the bottom of hob (see picture) after installation.
Adjust the bracket position to suit for different table top
thickness.
A. Bracket
B. Screw
C. Sealing Strip
Cautions
1. The induction hotplate must be installed by qualified
personnel or technicians. Please never conduct the
operation by yourself.
2. The hob will not be installed directly above a
dishwasher, fridge, freezer, washing machine or
clothes dryer, as the humidity may damage the hob
electronics
3. The induction hotplate shall be installed such that
better heat radiation can be
ensured to enhance its reliability.
4. The wall and surrounding areas affected by heat
above the table surface shall withstand heat.
5. To avoid any damage, all cabinetry, work surfaces
and adhesives must be resistant to heat.
Connecting the hob to the mains power supply
This hob must be connected to the mains power supply
only by a suitably qualified person.
Before connecting the hob to the mains power supply,
check that:
1. The domestic wiring system is suitable for the power
drawn by the hob.
2. The voltage corresponds to the value given in the
rating plate
3. The power supply cable sections can withstand the
load specified on the rating plate.
To connect the hob to the mains power supply, do not
use adapters, reducers, or branching devices, as they
can cause overheating and fire.
The power supply cable must not touch any hot parts
and must be positioned so that its temperature will not
exceed 75°C at any point.
Check with an electrician whether the domestic wiring
system is suitable without alterations.
See diagram below.
Any alterations must only be made by a qualified
electrician.
• If the cable is damaged or to be replaced, the
operation must be carried out the by after-sale agent
with dedicated tools to avoid any accidents.
• If the appliance is being connected directly to the
mains an omnipolar circuit-breaker must be installed
with a minimum opening of 3mm between contacts.
• The installer must ensure that the correct electrical
connection has been made and that it is compliant
with safety regulations.
• The cable must not be bent or compressed.
• The cable must be checked regularly and replaced
by authorised technicians only.
15
Advertisement
Table of Contents
