Victron energy Color Control GX Manual page 12

Color Control GX manual [Victron Energy]
Configure automatic starting and stopping of pump based on tank level(sender) information. Pump auto start/stop with Color Control GX (/live/ccgx:pump_start_stop)
Relay
Function
Polarity
Services
ModbusTCP
VRM two-way communication
When using a VE.Bus system, it is possible to configure the severity of problems on the VE.Bus system that should cause a notification to show up on the CCGX (and make it beep):
Disabled: The CCGX will never beep or show a notification
Alarm only: The CCGX will only beep and a show a notification when the VE.Bus system switched off in an alarm condition.
Enabled (default): The CCGX will beep and show a notification
When all done, don't forget to change the access level to user when required.
Click the thumbnail below to see the complete menu-tree:
https://www.victronenergy.com/live/ccgx:start
Alarm relay Select the relay function. Possible functions are 'Alarm relay', 'Generator start/stop', 'Tank pump' and 'None' (disabled).
Normally open Select the polarity of the relay on the back of the CCGX. 'Normally open' or 'Normally closed'. (Note that setting it to normally
closed increases the CCGX power draw.)
Off This setting enables the ModbusTCP service. More information about ModbusTCP in this document:
https://www.victronenergy.com/upload/documents/Whitepaper-Data-communication-with-Victron-Energy-products_EN.pdf
[https://www.victronenergy.com/upload/documents/Whitepaper-Data-communication-with-Victron-Energy-products_EN.pdf]
No Enable remote configuration and firmware updates. VE Power Setup manual (/live/ccgx:ccgx_ve_power_setup)
(/live/_media/ccgx:menustructure_ccgx.jpeg)
2018-07-31, 10*05 AM
Page 12 of 32