Fisher & Paykel ACTIVESMART RS36A72 Installation Manuals page 24

For Fisher & Paykel Stainless steel door panels only.
IMPORTANT!
Remove the protective film before hanging
the door panels.
Hang all door panels onto M8 studs and
1
align the side bracket forks onto the
refrigerator door (A).
– Ensure the forks are positioned around
the body of the side screws (M5x10 pan
head Phillips screw).
Push the product until the door panels are flush.
2
– Depending on your installation design this
will be flush with your adjacent cabinetry
or your framework.
Place a ruler on the front of the product to check
3
flushness top and bottom, left and right (B).
Ensure the gap between the top of the door
4
panel and the top cabinetry is no greater than
1/4" (7mm).
– To reduce this gap, raise the product
by turning all four adjustment nuts the
same number of turns.
IMPORTANT!
Failure to follow these steps can lead to
difficulties in door panel adjustment and
cosmetic cap fitment.
Lock top inner panel side screws to allow
5
opening the doors without affecting
adjustment. (Open the left door to lock the
right screws and vice versa (C).)
C
22
!7 HANG NON-WATER DISPENSING DOOR PANELS
B
Place a ruler on the
front of the product to
check flushness top and
bottom, left and right.
A
D
All door panels have
6
full axis adjustment to
ensure they are flush
with adjacent walls.
To adjust the height
of each panel, turn
the stud clockwise
to raise or counter-
clockwise to lower
the door panel (D).
Secure side bracket forks by tightening
8
side screws (F).
Repeat this process for all door panels.
Note:
For depth adjustment loosen side screws x4,
● ●
adjust panels and then retighten once satisfied.
Further adjustment of door panels can be achieved
● ●
by removing door panels then loosening the fixing
screws for the hanging bracket and moving the
bracket sideways to suit.
E
Once satisfied with
7
the alignment, secure
M8 studs with M8
washer and M8 nut
(E). The top of the
stud must remain
below the top face of
the door panel.
F