Fisher & Paykel ACTIVESMART RS36A72 Installation Manuals page 22

The assembly of Fisher & Paykel (Stainless steel) door panels and custom door panels are outlined below.
To protect the finish of the Fisher & Paykel Stainless steel door panels, leave protective film on the panels
when hanging and remove film only when installation is complete.
If using custom door panels, ensure they are prepared as per 'Custom door panel installation dimensions' section.
French door panels
Mounting handle (A)
1
For Fisher & Paykel door panel sets, remove
the plastic plugs from the handle holes (4x).
Align the handle to the holes and secure with
M5x25 pan head socket screws (4x).
For custom panels, ensure the handle is secured
2 9/16" (65mm) from the inner edge of the panel
to the center. This will avoid interference with the
bracket installation.
Hanging bracket (B)
2
For Fisher & Paykel door panel sets, align the
bracket to the holes and secure with M5x14 mush
Phillips SS screws (4x).
For custom panels, secure bracket with #8x16 mush
washer screws (4x).
Side brackets and straps (C)
3
For Fisher & Paykel door panel sets, align bracket
and strap to the holes on the side of the panel and
secure with M5x14 mush Phillips SS screws (2x).
For custom panels, secure bracket with #8x16 mush
washer screws screws (2x).
Repeat this process for
all brackets and straps,
and remaining French
door panel.
20
!5 ASSEMBLE DOOR PANEL SET
B
C
Drawer door panel
Mounting handle (D)
4
For Fisher & Paykel door panel sets, remove
the plastic plugs from the handle holes (4x).
Align the handle to the holes and secure with
M5x25 pan head socket screws (4x).
For custom panels, ensure handle screw heads
are counter sunk into the back of the panel to
avoid interference with hanging bracket.
A
Hanging bracket (E)
5
For Fisher & Paykel door panel sets, align the
bracket to the holes and secure with M5x14
mush Phillips SS screws (6x).
For custom panels, secure bracket with #8x16
mush washer screws (6x).
Side brackets and straps (F)
6
For Fisher & Paykel door panel sets, align
bracket and strap to the holes on the side of
the panel and secure with M5x14 mush Phillips
SS screws (2x).
For custom panels, secure bracket with #8x16
mush washer screws (2x).
Repeat this process for all brackets
and straps.
D
E
F