Table of Contents
Advertisement
5-6) ALARM RECORD MODE
The initial setup status of ALARM/MOTION RECORD SETUP menu is shown below.
ALARM/MOTION RECORD SETUP
ALARM RECORD ENABLE
MAIN ALARM TIME
PRE ALARM TIME LIMIT
POST ALARM TIME LIMIT
MOTION DETECTION
SENSITIVITY
MOTION CH SETUP...
1. ALARM RECORD ENABLE
If you want to start recording when Alarm rings, then select ON. If you do not want to start recording
when Alarm rings, then select OFF. If you set ALARM RECORD ENABLE to ON and exit the
menu, system starts recording whenever Alarm is activated.
The following screen shows that ALARM recording is in progress when ALARM is activated.
It showsIt shows the ALARM for Channel 4 is activated with an "A" mark.
[ON/OFF]
CAM1
A
CAM4
CAM7
2. MAIN ALARM TIME
- Set the time to record video and audio when motion is detected or alarm is activated.
[OFF ,10SEC ,20SEC ,30SEC ,1MIN ,2MIN ,3MIN ,4MIN ,5MIN ,AUTO]
- Use
3. PRE ALARM TIME LIMIT
- PRE ALARM recording is a feature that recognizes what kind of conditions were present
immediately before motion was detected.
PRE ALARM TIME LIMIT can be set to record 1-5 seconds of video/audio right before motion
detection or an ALARM occurrence. The System memory always saves up to 5 seconds of video
and audio data. When motion is detected or an ALARM occurs, ALARM recording starts and
PRE-ALARM data is simultaneously recorded from the System memory to HDD up to the time
length set in PRE ALARM TIME LIMIT.
[OFF ,1SEC, 2SEC, 3SEC, 4SEC, 5SEC]
- Use
05/01/05
00:00:01
OFF
10 SEC
1 SEC
OFF
OFF
NORMAL
05/01/05
00 : 00 : 01
CAM2
CAM3
CAM5
CAM6
CAM8
,
,
,
,
key to make changes.
,
,
,
,
key to make changes.
English-5-8
Advertisement
Table of Contents
