Network Setting; Connection Mode - Samsung SDS-P5080 Quick Start Manual

4.
After filling in the information, Click <OK>.

Network Setting

❒ Connection Mode

1.
Click on Network and select <Connection Mode>.
If there occur a problem with Connection Mode, check the connection
as "Installing your system" on page 1.
If you still have a problem, contact the nearest service center for more
information.
2.
Under <Connection> Tab.
Check <Connection Mode> is set to <Dynamic IP> as default.
If it connected successfully, you can see the success comment.
J
If you know Static IP information from your router, please select
<Static IP> and enter IP address, Gateway, and Subnet Mask etc.

M
Please refer to the Router Guide in provided CD when you use a static IP.
3.
Under <Protocol> Tab.
J
Write down your IP, Port(TCP) and Webviewer Port below.
1
IP
2
Port(TCP)
4.
When completing the setting, click <OK>.
4_ English
3
Webviewer Port
1
2
3