Table of Contents
Advertisement
4. FACTORY RESET
- When FACTORY RESET is performed, the setup value will factory default setting when
initialization starts.
1. Select SYSTEM SETUP from MENU screen.
2. From the SYSTEM SETUP submenu, set FACTORY RESET to ON.
3. When you exit MENU, the phrase "FACTORY RESET" appears on the monitor and the initialization
starts.
[ON/OFF]
- Use
5. SYSTEM ID
- Runs the remote control when the remote control ID and system ID settings are identical.
Does not run if they are different. [0-9]
- Use
6. LANGUAGE
- Show language type of SYSTEM screen.
(ENGLISH)
5-9) NETWORK SETUP
This section of the manual is intended for users who will install this security system in a network
environment.If you have difficulty setting the network,we recommend contacting your network
administrator.
• Static
• DHCP
• DSL (PPPoE)
•
Function: Allows users to select the STATIC (fixed) IP, DHCP, PPPoE of Setting.
•
Setting method: Move to #7, NETWORK SETUP MENU by using
MENU, then press the ENTER SWITCH to display the OSD as shown in the figure below.
(The figure shows the initial setting status)
NETWORK SETTING
1. NETWORK ACCESS
2. HTTP PORT
NETWORK STATUS
IP
GATEWAY
SUBNETMASK
DNS 1
DNS 2
MAC ADDR
MOVE TO EACH item by using
,
,
,
,
key to make changes.
,
,
,
,
key to make changes.
05/01/05
STATIC...
00080
ADDR
192.168.1.200
192.168.1.65
255.255.255.0
168.126.63.001
168.126.63.002
00:30:6f:ff:00:00
English-5-12
00:00:01
KEY, and using
KEY to change the set value.
KEY in the SETUP
Advertisement
Table of Contents
