Linksys WIP310 User Manual page 60

8. Repeat steps 5-7 until you have entered all four port ranges for the IP Phone.
Application Start and End
Internet phone 1 5060 to 5061
Internet phone 2 53 to 53
Internet phone 3 69 to 69
Internet phone 4 10000 to 20000
9. Check the Enable option for the port services you want to use.
10. When you have completed the configuration, click the Save Settings button.
4. The power LED does not light up.
Go through this checklist until your problem is solved:
• Remove the IP Phone's battery from its compartment. Wait five seconds while the IP Phone resets itself.
Insert the battery and power on the IP Phone.
• You may be using the wrong power adapter. Make sure the power adapter you are using is the one
included with the IP Phone.
5. I can not access the web-based utility.
This occurs because the computer the user is trying to access the phone with is not connected to the same
network as the phone. The solution is to have both the phone and the computer on the same network.
Appendix A: Troubleshooting
Common Problems and Solutions
Protocol IP Address
UDP (IP address of IP Phone)
UDP (IP address of IP Phone)
UDP (IP address of IP Phone)
UDP (IP address of IP Phone)
Enable
X
X
X
X
Wireless-G IP Phone
53