Linksys WIP330 Quick Installation

®
A Division of Cisco Systems, Inc.
Package Contents
• Handset
• Power Adapter
• Quick Installation
• User Guide on CD-ROM
Wireless-G
IP Phone
Quick Installation
Voice
Model No. Model No. WIP330
1
Inserting the Battery
To insert the battery, follow these
instructions:
A
Remove the cover of the
battery compartment. Push
down on the button and
slide the cover downward.
B
Insert the battery. Make sure
the metal contacts of the
battery line up with the
metal contacts of the
battery compartment.
C
Insert the door and slide it
upward until it snaps into
A Button
place.
Metal Contacts
B
2
Powering on the IP Phone
Make sure you have the account
information, including necessary
Headset
IP Phone settings, supplied by your Jack
Internet phone service provider.
USB Port
If you already have an account
set up with your Internet phone
service provider, then proceed to
step A. If you do not have an
account, then go to the website
of your Internet phone service
provider and sign up for service.
Proceed to step A.
A
Plug the USB mini-B
connector of the included
Power LED
power adapter into the USB
mini-B port of the IP Phone.
Then connect the power
adapter to a standard
electrical outlet.
B
The power LED will flash,
alternating between blue
and purple.
NOTE: For the initial charge,
allow the battery to charge
Soft Key
for at least 10 hours.
Navigation Pad Soft Key
and Center
Selection Key Power or
End Call
Call
Different Key
Enter Symbol
Choices or + Sign
or Space
3
Setting Up the IP Phone
Before you begin, make sure your
network has an active Internet
connection.
A
Press the Power button for
two seconds.
B
The IP Phone will scan for
wireless networks and then
B
display a list of networks.
1
NOTE:
The following are descriptions
of your navigation choices:
•
Navigation Pad - Scroll through
menu choices
•
Center Selection Key - Make
selections or save changes
• Clear Soft Key - Use for a
backspace
B
2
• Exit Soft Key - Cancel changes
and return to the previous screen
Scroll through the list, and
press the center selection
key to select a network.
If the network you want is
not shown, select Rescan.
C
The IP Phone will C
automatically connect to
the network.
If WEP security is enabled,
select the appropriate
transmit key from the Key
Index, and then enter the
network's WEP key. Press the
center selection key.
WEP
If WPA security is enabled,
then enter the network's
WPA key. Press the center
selection key.
WPA
D
You will be notified when the
IP Phone has connected to
the network, and a
checkmark will appear next
to the name of the network.
Select Exit.
D
E
The standby screen will
appear. Select Menu.
E
F
Phone Settings will be
highlighted. Navigate the
menu choices, and then
select SIP Settings.
F