Bad Output Power Error, No Or Low Output Transmitter Power - Primex XR Series Troubleshooting Manual

Bad Output Power error, no or low output Transmitter power

Symptoms
All or some of the below symptoms may be present.
Red LED is flashing on the Transmitter front display.
l
Transmitter Diagnostic Menu displays Bad Output Power - indicates the Transmitter is not transmitting at the appropriate
l
power level.
Clocks may be displaying a visual signal loss indicator due to they have not received a time update for three days; Analog
l
Clock second hand is stepping and a Digital Clock/Timer colon is flashing.
Problem
Transmitter has no or low power that may be due to hardware failure event or bad power.
Analyze
1. If the red LED is flashing, start at
front display
and work your way through all subsequent troubleshooting sections.
2. If the red LED is not flashing, check power using the same steps in topic
correct
.
3. Look for the letter "LP" (Low power) behind the time on the front display of the Transmitter.
4. Check Transmitter for power issues, completing the steps in
synced
.
5. Verify the antenna connections and cables look good showing no damage and the antenna is mounted correctly and not
touching anything or extremely close to anything by completing the steps in
Solution
1. If power to the Transmitter power supply is bad, resolve the issue.
2. If the UPS (surge protector/battery backup) is defective, bypass it until it can be replaced.
3. If power to the Transmitter power supply is good, but its output is bad replace the power supply as the first step.
4. If power to the AMP is bad, replace the sun power supply.
Red LED flashing and Transmitter GPS communication symbol is not displayed on
Transmitter continues to power cycle and does not stay
Transmitter front display time and date are not
VWSR error code
.
23