Warnings - Gage Bilt GB745SH User Manual

MUST BE UNDERSTOOD TO AVOID
SEVERE PERSONAL INJURY
Do not pull fastener unless it is placed in an
assembly, pin will eject forcibly when pintail breaks
off. Severe personal injury may result.
When operating, repairing or overhauling tool, wear
approved eye protection. Do not look in front of
nose assembly or rear of tool when installing
Do not operate if deflector, bottle, catcher bag or
vacuum tube is removed or damaged, broken
pintails may eject forcibly from rear of tool. Severe
personal injury may result.
Keep Nose Assemblies clean and free of chips and
Do not use beyond the design intent.
Tool must be maintained in a safe working
condition at all times and examined on a regular
daily basis for damage or wear. Any repair should
be done by qualified personnel trained on Gage Bilt
procedures.
Where prolonged use is foreseen, it is
recommended a tool balancer be used. Check
suspension device to ensure that it is secure.
Do no use tool in explosive atmosphere.
It is recommended operator wear a suitable glove
during operation where prolonged use is expected.
S/N: 1033 AND ABOVE
PLEASE CONTACT GAGE BILT FOR ALL OTHER SERIAL NUMBERS.
SAFETY WARNINGS
PLEASE READ THIS MANUAL BEFORE
SERVICING OR USING THIS TOOL.

WARNINGS:

WARNING
WARNING
fastener.
WARNING
CAUTION
debris.
CAUTION
WARNING
WARNING
WARNING
WARNING
Shock:
CAUTIONS:
SHOW CONDITIONS THAT WILL
DAMAGE EQUIPMENT OR STRUCTURE
Do not operate without Stat-O-Seal (S572) and cap
screws (402482). Pressurized hydraulic oil may
cause severe personal injury.
Always disconnect tool from power source before
performing any maintenance to any tool or nose
Ensure that all connections are properly secured
before connecting to power.
Ensure that nose assembly and tip are properly
matched for the fastener being installed.
Be sure there is adequate clearance for tool and
operator's hands before proceeding. Keep fingers
clear of any moving parts. Keep fingers clear from
fasteners and installed materials. Severe personal
injury may result.
It is required to use hearing protection. A test was
carried out in a simulated work environment where
the background level was 73.2 dB (A). In this
condition the max level was 81.5 dB (A). Therefore,
it is required where prolonged use, hearing
protection be used.
Risk of crushing exists if nose assembly is not
It is recommended tool be operated 50 out of every
60 minutes, where prolonged use is expected.
Tool is not to be used as a hammer.
Air pressure not to exceed 100 psi (6.9 bar).
3
WARNING
WARNING
assembly.
WARNING
CAUTION
WARNING
WARNING
WARNING
attached.
WARNING
CAUTION
WARNING
7/12 REV. 8/14