Installing The Server Into A Telco Rack; Figure 6 Installing The Server Into A Telco Rack - Quantum NDX Series User Manual

Chapter 3: Server Installation
Installing the System into a Rack
Installing the Server
into a Telco Rack
Figure 6 Installing the Server
into a Telco Rack (with optional
front bezel shown)
18
To install the Quantum NDX NAS 1U Rack into a Telco type rack, use two
L-shaped brackets on either side of the chassis (four total). First,
determine how far the server will extend out the front of the rack.
Larger chassis should be positioned to balance the weight between
front and back. If a bezel is included on your server, remove it. Then
attach the two front brackets to each side of the chassis, then the two
rear brackets positioned with just enough space to accommodate the
width of the rack. Finish by sliding the chassis into the rack and
tightening the brackets to the rack.
Quantum NDX NAS 1U Rack User's Guide