Initial Setup
First Use
Connecting to Ethernet
Quantum NDX NAS 1U Rack User's Guide
Initial Setup and System
This chapter describes activities required for initial setup, provides a
hardware overview, and describes control panel buttons and control
panel and hard drive carrier LEDs.
When you first use the Quantum NDX NAS 1U Rack, connect the unit to
a keyboard, monitor, and mouse, and proceed with several Microsoft
Windows setup wizards. This is a requirement for initial setup only.
The Quantum NDX NAS 1U Rack comes with three RJ45 ports (see
Figure 1
and
Figure 2
together. Connect the NDX NAS to your network using these two ports.
The third RJ45 port is for IPMI (Intelligent Platform Management
Interface). This port is used or system monitoring, troubleshooting and
technical support.
on page 3. Two are ethernet ports positioned
Chapter 4
Interface
23