Removing The Chassis Cover; Removing/Installing A Drive; Power Supply; Power Supply Failure - Quantum NDX Series User Manual

Removing the Chassis
Cover
Removing/Installing a
Drive

Power Supply

Power Supply Failure

Quantum NDX NAS 1U Rack User's Guide
1 Grasp the two handles on either side and pull the unit straight out
until it locks (you will hear a "click").
2 Depress the two buttons on the top of the chassis to release the top
cover and at the same time, push the cover away from you until it
stops. You can then lift the top cover from the chassis to gain full
access to the inside of the server.
1 With the chassis cover removed, unplug the power and data cables
from the drive.
2 Locate the locking tab at the rear of the drive. It will be on the left
side of the drive when viewed from the front of the chassis.
3 Pull the tab away from the drive and push the drive unit out the
front of the chassis.
4 Add a new drive by following this procedure in reverse order. You
may hear a faint *click* of the locking tab when the drive is fully
inserted.
5 Remember to reconnect the data and power cables to the drive
before replacing the chassis cover and restoring power to the
system.
The Quantum NDX NAS 1U Rack has a single 350 watt power supply.
This power supply has the capability of operating at 100 - 240 input
volts. Depress the main power button on the front of the chassis and
then unplug the AC power cord to completely remove power from the
system before removing the power supply.
If the power supply unit fails, the system will shut down and you will
need to replace the power supply unit. Replacement units can be
ordered directly from Quantum (see contact information in the Preface).
Chapter 5: Advanced Chassis Setup
Power Supply
33